guidenco setup

Install

Flash Raspberry Pi OS, enable SSH and sign in, then run this once:

curl -fsSL https://raw.githubusercontent.com/onvo-ai/guidenco/main/install.sh | sudo bash

It works out which capture device you have, sets the boot overlays, and starts the service. Reboot when it finishes — the USB gadget that types and moves the mouse only appears at boot. After that the Pi advertises itself over Bluetooth and you can set it up below, no network needed.

Connection

offline

Pick the device named guidenco. The Pi must be powered on and within a few metres.

Status

Host: —
Network: —
Address: —
Screen: —
Input: —

Public URL

—

This changes every time the bridge restarts, which is why it lives here.

Wi-Fi

Network Or enter a name (for a hidden network) Password

The password is sent to the Pi and never read back. Joining a new network drops the current connection, so this page may go quiet for a few seconds.